The Lure Forums banner

DIY rod turner..

3051 Views 1 Reply 2 Participants Last post by  Mike Oles
Wood Audio equipment Gas Electrical wiring Machine

Sorry for the rubbish picture but you get the drift I hope, the motor was £2ish on eBay and the peice of angle was lying about in the workshop.. It's about 4RPM on 240v and works a treat albeit slightly crude!! I pushed a peice of soft plastic tube onto the motor shaft and then either tape the end of the blank to the tube or if I'm in luck simply push the blank into the tube..
If anyone is interested search for microwave turntable motor or synchronous motor on eBay...
I hope this helps someone who builds rods on a budget!!
Tight lines all!!
See less See more
  • Like
Reactions: 5
1 - 2 of 2 Posts
No need to pay silly money on a rod dryer, good stuff Luke.
  • Like
Reactions: 1
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.