The Lure Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
6,632 Posts
Discussion Starter · #1 ·
I was wondering if anyone on here has had a rod re-rung, one of my rods has a couple of rings that are no longer looking there best. I was wondering if it might be possible to have it re-rung with better quality rings (some thing like stainless steel SIC) Which probably cost more than the rod did, but I like the rod enough to make it worth while.
Any ideas cost wise??
 

·
Registered
Joined
·
6,632 Posts
Discussion Starter · #6 ·
Five pounds per ring sounds pretty reasonable if the work is of the quality you are talking about MrFish. Plus the cost of the rings wouldn't be too bad, especially to restore a good rod for more bassing.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top