Ring Upgrade

809 Views 5 Replies 4 Participants Last post by Dave Irving, Dec 28, 2009

Dave Irving

Discussion Starter · Dec 27, 2009

I was wondering if anyone on here has had a rod re-rung, one of my rods has a couple of rings that are no longer looking there best. I was wondering if it might be possible to have it re-rung with better quality rings (some thing like stainless steel SIC) Which probably cost more than the rod did, but I like the rod enough to make it worth while.
Any ideas cost wise??

Save

1 - 2 of 6 Posts

Alex Jordan

· #2 · Dec 28, 2009

I looked into this a while ago - top of the line Fuji Ti Gold Cermet from Mudhole were quite reasonable - its the whipping and time that will catch you out!

http://www.mudhole.com/Shop-Our-Catalog/Gold-Cermet

Save

Alex Jordan

· #4 · Dec 28, 2009

Hmmm same here - both lower guides on my 270 and U One need re-doing ... partly my fault through knocking them and being lazy and using them to unplug the top and bottom rod sections!

Save

1 - 2 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month